I had to write about an interesting discussion I had yesterday with a CAE peer – a discussion on estimating the accuracy of analysis results. Finite Element theory has traditionally preached stress convergence. Instructors and technical staff tell the user to work towards making sure the mesh is fine enough at high stress areas so that the stress values do not change appreciably over successive runs.
To supplement this procedure, COSMOS has gotten ever so easier to use as well. Any trained designer/engineer can pick up meshing tips pretty fast. COSMOS makes it so straight forward, that the user only has to know two options in meshing – creating a mesh, and applying mesh controls.
Amongst all this commotion on accuracy, the user ends up overlooking a fundamental objective in performing analysis – GAINING DESIGN INSIGHT!! Â More often than not, the objective of analysis is to understand where the high stresses are in a model, and try to mitigate their effects. The question here is:
Is it that critical to know exactly what the values of high stresses are at that location?
More often than not, you would answer no to this question. Granted that there is going to be a need every now and then to work towards the exact values!! But in most cases, one can bank upon design experience to estimate the necessary additional strength at a high stress location.
The locations of the high stress are not going to change, the values might!! But once the locations are identified, then in most cases, it is just a matter of applying design principles to strengthen these areas. The exact converged value of stress becomes a mute number that only quantifies the already known weak locations.
I see major advantages to considering design insight:
- Saves time involved in working towards stress convergence, and worrying about divergence issues.
- Saves discussions on what are the most accurate stress results
- Gets one away from modeling FEA-focused features (like fillets etc.) to avoid singularities
- Gets one thinking about the design than analysis
Using analysis to understand the model may be the thing of the future. Use it to your advantage – if you know a design can fail if the stresses seem to localize at a weak spot, try to focus time and energy on directly strengthening that location.
Hey!! If a dartboard can give you points even if you miss bulls-eye, then why not analysis!!
Your destination for design and manufacturing technology